06-10-2020 16
:
44
Pagina 1 van 4
http://manual.zwave.eu/backend/make.php?lang=en&sku=POPE701479
Popp
Flow Stop 2
SKU: POPE701479
Quickstart
This is a
Powered device
for
Europe
. To run this device please connect it to your mains power supply. For inclusion and exclusion press the red button on the
top of the enclosure 3 times. Attention:
You must not move the rocker arm manually without unlocking it mechanically
pulling on the ring on the bottom
side of the enclosure.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer,
distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this
equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (
two-way communication
) and
every mains powered node can act as a repeater for other nodes (
meshed network
) in case the receiver is not
in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be
used together with any other certified Z-Wave
device regardless of brand and origin
as long as both are suited for the same frequency range.
If a device supports
secure communication
it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of
security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
Flow Stop 2 moves the operating handle of a ball valve allowing to stopping the flow of gas or water. It can be mounted non-intrusive on any pipe size between 0.5 and
1.5 inch. This means the original water or gas pipe will not be opened or manipulated and it is possible to remove the Flow stop again without any damage to the water
or gas pipe. Installing the Flow stop will not tamper or change any security measure applied or your gas or water installation. The device is equipped with a powerful 12
V motor providing sufficient torque to open or close any ball valve within 10 seconds. A complete manual operation of the valve remains possible due to the clutch
release bearing. The device can be operated using the local button and remotely using Z-Wave wireless communication. Various functions protect the flow stop from
accidental or intentional misuse:
Z-Wave Communication applies enhanced security implementing the Security Command Class. This does not only protect the device against burglars that want
to do harm to the home (e.g. waste water by opening the valve to watering system). It
s also protecting better against jamming of the communication link.
Configuration of the local LED. The user can now decide if the blue LED shall indicate open or close state
Unsolicited report of any state change of the flow stop to the controller.
Second communication channel to report manual operation of the device. Here up to 5 other devices can be operated independent of the controller, e.g. to
announce any local operation.
The remote operation of the device can be limited to
no
,
only open
or
only close
to further protect against malfunction.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it
must be in factory default state.
Please make sure to reset the device into factory default. You can do this
