Pope 101BV1800, Operator'S Manual, Page: 7 / 12

ASSEMBLY –
continued
7
To assemble as a VACUUM
See Figs 3-6
Follow these steps to assemble as a vacuum:
Fig 3
Ensure that the blower vacuum unit is switched off and is not connected to the mains
power source while assembling this unit.
WARNING
Fig 4
1. If the unit is assembled as a blower, remove the blower tube
and blower inlet cover from the motor housing. (see Fig 3)
2. Connect the top blower tube to the vacuum inlet cover, and
attach lower vacuum tube. Ensure that the angle of the
vacuum inlet is positioned correctly as per Fig 4.
3. Fit the Bag Connection Mount securely to debris collection
bag. Ensure the velcro straps are tightened. (see Fig 5)
4. Hook the Vacuum inlet cover to the latch on the Bag
Connection Mount, then attach to the rear of the engine
housing. The latch should "snap" into place. (Fig 6)
Fig 5 Fig 6