Pope 101BV1800, Operator'S Manual, Page: 6 / 12

ASSEMBLY
6
To assemble as a BLOWER
See Fig 2
Follow these steps to assemble as a blower:
1. Install the blower tube on the motor housing.
2. Hook the front of the blower inlet cover to the latch on the blower tube.
3. Attach the rear of the blower inlet cover to the latch on the motor. This should "snap" in place.
4. The blower is ready for use.
Note: The Motor will not run if the blower inlet cover is not connected or is incorrectly connected.
Fig 2
Ensure that the blower vacuum unit is switched off and is not connected to the mains
power source while assembling this unit.
WARNING