Warranty Card
Titan Series Filtration Systems
Poolrite Equipment Pty. Limited
Your Poolrite Filtration Equipment is
manufactured to the highest possible
standards and most up-to-date technology.
Accordingly the equipment carries the
following Warranty, should a fault occur
due to faulty manufacture or materials.
Important
In the event of a fault covered by
Warranty occurring, the Purchaser must,
in the first instance, contact Poolrite
Equipment Pty. Ltd. or the closest
authorised Poolrite Distributor.
1. All components in the Filtration
System (with the exception of the tank
part) carry 1 year (12 months) warranty
from the Date of Purchase by the
Owner.
2. (10 year extended warranty effective
from 1-1-93).
The Filter Tank Component is the most
important part of your Filter System. Due
to
Poolrite’s
Advanced
Moulding
Technology the Tank Part carries a
special Extended Warranty of 10 years.
The terms of this Warranty cover Full
replacement of defective Filter Tank Part
for a period of 5 years (60 months) and
additionally for a further 5 years (60
months) the Tank Part will be replaced at
pro-rata cost from the date of purchase
by the owner. No claim in pursuance of
this Warranty will be recognised unless
received by Poolrite during the Warranty
period.
The “Tank Part” is defined as the Filter
Housing Moulding only, without any
attachments such as gauges, clamp
band, internal septums fittings or
plumbing, etc.
3. The Warranty is void if the following
are not adhered to:
• The equipment must be installed and
used in accordance with the instructions
supplied.
• The pump electric motor is not
covered by this Warranty in the case of
the water damage or damage caused
by extension leads.
• The pump motor must have proper
ventilation.
• The equipment is designed to be used
in swimming pool water, balanced in
accordance
with
the
Langlier
Saturation Index with a pH of 6.8 to 8.0
that is regularly treated with a sanitising
system utilising chlorine either added
in compound form or generated in situ
in concentrations as recommended by
the relative State Health Departments.
Should other chemical treatment
systems or parameters be used,
Poolrite will not be responsible for
damage done by corrosion, scaling
or stress cracking of equipment or
for shortened filter cycles resulting
therefrom.
• The Pressure Gauge will not be
covered by Warranty if damaged by
water, if the gauge cover is not firmly
affixed.
• If, in the opinion of Poolrite, the
equipment has been subjected to
other than normal pool use, or
improperly serviced/maintained, the
Warranty will be void.
This Warranty is applicable to workman-
ship and materials. Poolrite will replace at
no charge, all parts returned freight paid,
which display faulty workmanship or
materials.
Poolrite Equipment Pty. Ltd. accepts no
responsibility for loss, damage or injury to
person or property arising from Warranty
failure of equipment, or installation of that
equipment, unless with the express
authority of Poolrite. Any repair or
replacement shall be provided by Poolrite
or its Authorised Distributors and this
Warranty shall not extend to any
expenditure otherwise incurred.
Operational Check Points
Weatherproof gauge cover is in position.
Filter pump should not be connected via extension leads.
At least 150mm clearance be provided at fan cowl end (rear) of motor for efficient
ventilation.
Should filter system be housed in an enclosure, provision must be made for
adequate ventilation.
Filter system must be installed in a position with effective drainage to guard against
potential flooding in heavy rain or malfunctions in plumbing.
A Diatomaceous Earth Filter system must not be run for any period without the
correct charge of Diatomaceous Earth or approved filter powder.
The pool water level must be at least half way up the skimmer box opening.
Make sure both skimmer box basket and pump basket are in place.
Do not operate the filter system in FILTER position unless the free chlorine level is
between 0.5 and 2.0ppm and the pH level is between 7.2 and 7.6 for concrete
pools and 6.8 and 7.2 for other types of pools.
Do not vacuum clean the pool when the valve is in BACKWASH position.
Important
Read the following instructions carefully to ensure trouble free efficient operation
of your filtration system for many years.
Failure to adhere to the above directions will void the Warranty.
Warranty Card
Name of Purchaser
Address
Purchased From
Date
Equipment and Model
IMPORTANT: This card must be filled in and
returned to Poolrite Equipment Pty. Limited
within 14 days of purchase to render the
Warranty effective.
Queensland Head Office
Sales & Export Brisbane
415 Creek Road,
P.O. Box 520,
Mt. Gravatt. QLD 4122
Telephone: (07) 3323 6555
Facsimile: (07) 3323 6500
Poolrite Equipment Pty. Ltd.
Unit 22, 761 Great South Road,
Penrose. Auckland
New Zealand.
Telephone: (09) 571 0210
Facsimile: 0800 766 574
