Step By Step Instructions
Numbers in parenthesis refer to hardware shown on page 3.
On the non-motor end, feed the rope
around the pulley of the non-motor end
pulley bracket. Pull the rope through to
the motor end.
Feed the non-motor end rope behind the first
and second and third horizontal pulleys.
Pull the rope around the vertical pulley on the
front wall of the cover box.
On the motor end, feed the rope around
the first and second horizontal pulleys on
the back wall of the cover box.
Pull the rope around the vertical pulley on
the front wall of the cover box.
10
12
13
14
15
16
17
18
Run the rope from the non-motor end
along the backside of the cover box. The
rope should run through the rope loops (23)
to keep it from getting caught in the cover.
Space the rope loops evenly across the back
of the cover box.
Remove the guide from the end of the track.
Position the positive stop plate (49) over the
track so that it is 1-1/2 inches from the end of
the track.
Installing the Positive Stops
Mark the track through the center of the
holes in the positive stop plate (49). These
holes should be in the center line of the track.
Use a 1/4” drill bit to drill the holes in the
track.
© Latham Pool Products, Inc. 2016. All rights reserved.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
14 of 20