Pond Boss Olympus, Manual

Page: 5 / 6

PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
WWW.THEPONDBOSS.NET
Part Description
B 1/2 in. ID tubing adapter
C 5/8 in. ID tubing adapter
D 3/4 in. ID tubing adapter
E Flow control knob
F Front cover
G Impeller cover
H Shaft support
I Washer
J Shaft
K Impeller assembly
To disassemble pump for cleaning:
•
Always disconnect pump from the power source before cleaning.
•
Remove the inlet screen and impeller housing.
•
Remove the impeller/rotor assembly by gently pulling on the impeller blades.
•
Use a soft cloth or brush to clean the impeller/rotor assembly area inside the pump.
•
Clean the inlet screen, impeller housing and impeller with warm, soapy water.
•
Reassemble the pump and check for proper operation.
TROUBLESHOOTING
•
Set the flow control switch on pump to maximum (+) before operating. Once flow is
established, the pump can be adjusted to desired level. Remember to always disconnect
pump from the power source before handling.
•
If the pump operates but there is no flow, check to make sure that the pump is fully submerged.
•
If the pump operates but there is no flow, check the supply tubing for kinks.
•
If the pump operates but there is no flow, and if the pump is submerged and there are no kinks in
the supply tubing, lift the pump out of the water. Remove supply tubing at pump outlet and clean
tubing inside and out if necessary. Put pump back into water (outlet side up). Once water begins
to flow, reattach the supply tubing.
REPLACEMENT PARTS LIST
For replacement parts, call our customer service department at 1-888-755-6750, 8 a.m.-6 p.m., EST,Monday-
Friday, or email us at customercare@thepondboss.net.
B
C
D
H
I
K
J
I
H
G
F
E
Printed in China