PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
3. Insert Lower tower into basin. Line up notches in base and tower so that
the lower tower sits flush and level. Fig 3.
Fig. 3
4. Connect the water tube, which extends from the inside of the top tower, to
the outlet of the pump and place upper tower onto lower tower. Position
the towers on the basin and check to make sure tower is level. Fig4.
5. Turn the flow control knob on the pump to the maximum (+) setting.
6. Add clean water into basin. The water level should be
approximately 2~
3” below the top of the splashguard.
7. Test the initial flow of the fountain by connecting the power cord to a
properly grounded receptacle. Once the pump is plugged in the water will
begin to flow. If water splashes, unplug the power cord and adjust the flow
control knob counterclockwise on the water pump
. Fig 5 & 6.
Fig. 4
GFCI
Fig. 5
Fig. 6
8. Once satisfied with the flow of the water, setup the lights above
splashguard and adjust the beams to point towards the top of the tower.
Fig 7
Fig. 7
