19
6. Programming via the Ethernet interface
Changes to the basic configuration can only be done via the Ethernet interface. The programming as well as the
output of signals takes place via the RJ-45 jack. The streamer is programmed via the respective HTML user interface
and a connected computer. For this, an internet browser is required. The devices interface of the HDM 1 IP supports
the following Web browsers - Chrome, Safari, Firefox and Internet Explorer. For the initial installation, we
recommend a direct connection of the HDM 1 IP to a PC - without using a switch.
6.1 Network connection to the PC/laptop
System requirements:
→
PC/laptop with Ethernet interface 10/100Mbps
→
Internet browser (e.g. Windows Internet Explorer, Mozilla Firefox or similar)
Note on setting up a network connection:
PC and IP Streamer should be connected to the network via an Ethernet cable (CAT-5E or CAT-6). For connection
acquisition, the IP addresses of the device must first be matched. The factory settings for the network parameters of
HDM 1 IP are shown:
IP address:
192.168.001.230
Subnet mask:
255.255.255.000
Gateway:
192.168.001.001
The addresses of the network connection at the PC must be adapted to the IP address of the HDMI streamer
(Subnet mask: 255.255.255.0, IP address: 192.168.001.xxx). xxx must not match the IP address of the HDM 1 IP.
Also not allowed are the digits 0, 255 or already used IP addresses. If a proxy server is used, it must be disabled in
the network connections. These settings will be done at the PC under “Network connections
→
LAN connection
“.
After individualization of the IP addresses, the network connection between the devices can be established.
Establishing a connection:
Enter the IP address of the device (Standard IP address:
192.168.001.230
) into the addresses field of the
browser and press the
„Enter“ key to confirm.
The connection to the device is established and the associated login window will be displayed:
The access to the configuration menu is password protected. The factory settings are as follows:
Benutzername/Username:
admin
Passwort/Password:
admin
Note
Should the password or username be lost or forgotten, a general factory reset can be done by pressing the Reset
button (2). The device reverts to the basic access data and basic settings. Even individualized basic settings (exept
the Ethernet access data) are lost.
Summary of Contents for 5741690
Page 27: ...27 Notizen Notes...