15
1. Mounting and safety instructions
Please observe the following safety instructions in order to prevent any risks for persons and/or damage to the device, as well as to
contribute to environmental protection.
Important instructions
Please read the operating instructions for the device(s) carefully before putting into operation! The instructions contain important information on
installation, environmental conditions, service and maintenance. Save the operating instructions for later use. All operating instructions can be
found on our website at:
https://polytron.de/index.php/en/services/operating-manuals
Approved use
Use the device only at the permissible operating locations, under the permissible environmental conditions and for the purpose
described in the operating instructions. If there is no information about the intended use (e.g. operating location, environmental
conditions) or if the operating instructions do not contain any relevant information, you must contact the manufacturer of this
device to ensure that the device can be installed. If you do not receive any information from the manufacturer, the device must
not be put into operation.
Transport
Please check the packaging and the device for damages in shipment immediately upon receipt. Do not put a damaged device
into operation.
Transporting the device by the power cord is not permitted as this can damage the power cord or the strain relief. Insulation
that serves to protect against mains voltages can be damaged by excessive loads (e.g. fall, shock, vibration).
Attention
The rated voltage on the device must correspond with the mains voltage to be used. When operating devices with protection
class I, connection to power sockets with a protective conductor connection is mandatory. The instructions for operating the
device must be observed.
Grounding and potential equalisation
Please establish grounding and perform potential equalisation before initial startup. According to the currently valid version of
EN 60728-11, coaxial receiving and distribution systems must meet the safety requirements with regard to earthing,
equipotential bonding etc, even if the device is removed. Otherwise, damage to the product, fire, or other dangers can occur.
In addition, the earth connection on the device can be used. Other devices within touching distance are to be integrated in the
equipotential bonding. Operation without a protective conductor connection, device grounding or equipotential bonding is not
permitted. If damaged, the device must be taken out of operation.
The electrical system for powering the device, e.g. house installations must contain protective devices against excessive
currents, earth faults and short circuits. Follow all applicable national safety regulations and standards.
Connection cables
Always install the connection cables with a loop so that condensed and/or splashing water cannot run into the device.
Select installations site
Plan the installation location so that children cannot play with the device and its connections. The device should only be
installed on a solid, flat and most of all fire-resistant surface. Observe the operation position of the devices specified in the
operating instructions. Avoid strong magnetic fields in the surroundings. Too strong a heat effect or accumulation of heat will
have an adverse effect on the durability. Don't mount directly over or near heating systems, open fire sources or the like,
where the device is exposed to heat radiation or oil vapours. Mount fan-cooled and passively cooled devices so that the air
can be sucked in unhindered through the lower ventilation slots and heat can escape through the upper ventilations slots.
Ensure free air circulation, ventilation slots must not be covered. Do not place any objects on the devices. Installation in
recesses, alcoves etc and covering the installation site, e.g. through curtains is not allowed. To avoid heat build-up, the correct
installation position must be observed and all-round, free ventilation must be ensured in accordance with the information in the
operating instructions! When installing the cabinet, sufficient air convection must be possible to ensure that the maximum
permissible ambient temperature of the device is maintained.
Moisture
The devices have no protection against water and may therefore only be operated and connected in dry rooms.
Dripping/splashing water and high humidity damage the device. If there is condensation, wait until the device is completely dry.
Select the operating environment according to the specified IP protection class.
Heat
Housing parts near cooling fins and cooling fins themselves can get very hot. Therefore, you should not touch these parts.
Summary of Contents for 5741690
Page 27: ...27 Notizen Notes...