110-064
4
Installation
Locate the unit on a level surface, free from drafts and out of direct sunlight. Do not place it where there are
corrosive fumes, excessive moisture, high room temperatures, or where excessive dust is present.
The unit must be a minimum of 6 inches / 15.24 cm away from walls or vertical surfaces so that airflow around the
unit is not restricted. It should not be placed in cabinets or where exiting warm air or warm air from other devices
will be drawn into the air intake on the front of the unit.
NOTE:
It is recommended that your unit be run in ambient temperatures below 95°F / 35°C.
While the unit will operate at higher ambient temperatures, it may not be able to achieve
maximum cooling performance
Electrical Power
WARNING:
Make certain that the electrical outlet is the same voltage and frequency as your Low
Temperature Cooler. The correct voltage and frequency for your unit are indicated on the identification label.
IMPORTANT:
The use of an extension cord is not recommended. If one is necessary, it must be properly
grounded and capable of handling the total wattage of the unit. The extension cord must not cause more than
a 10% drop in voltage to the unit.
Verify that the Power Switch / Circuit Breaker is in the OFF position.
Connect the Electrical Power Cord to an appropriate electrical outlet.
WARNING:
DO NOT place your Low Temperature Cooler’s Power Switch / Circuit Breaker in the ON position
until you are ready to begin operation.
Immersion Probe (IP) Coolers
Positioning the Immersion Probe Assembly
Immersion Probe Coolers have a flexible hose connected to a probe which can be easily immersed in a
Dewar flask, cold trap, or bath requiring cooling.
When installing an Immersion Probe Cooler, make sure that the Immersion Probe Assembly is properly
positioned. It should not be twisted. Incorrect positioning of the Wand Assembly will cause your unit to
perform below specifications.
CAUTION:
Moving the Immersion Probe Assembly while the unit is operating may result in
damage.
www.
.com
1.800.561.8187