12
OPERATING YOUR POLYSHER
TM
Run the polishing cycle
Rotate the control knob clockwise to the
desired polishing time. A stream of solvent
mist will come from the nebulizer and the
part will begin rotating on the platform. In
a few minutes the mist should fill the entire
chamber. You can adjust the polishing
time any time during the polishing cycle
(remember that each illuminated segment
represents 5 minutes).The optimal time
depends on the concentration of alcohol
used, ambient temperature, the size of your
part, the condition of your nebulizer, etc.
Generally speaking 20-40 minutes is a good
starting range.
You can turn the chamber lighting on and off
by pressing the Chamber Light button. The
color of the mist lighting can also be adjusted
by pressing the control knob and then
rotating it until you see the desired color.
Press the OPEN/CLOSE button
The lift mechanism will lower the part into the
chamber and seal the top of the chamber. The
Chamber Seal warning light should turn off
when the lift mechanism reaches its lower
closed position. If it doesn’t, check to see that
the casing is properly seated.
You can let the Polysher
TM
run automatically until the timer expires, or you can stop
polishing at any time by rotating the control knob counterclockwise until no time
indicators are shown. In either case, tones will sound to let you know the smoothing
cycle has finished. The Polysher
TM
will then begin its “clearing cycle” during which
the chamber fan is run at high speed to clear the mist from the chamber.
Place a PolySmooth
TM
print on the
platform
To ensure even polishing, place the part in the
center of the platform.
1
2
3
