SH1-1 Assembly - July 2012
Page 4 of 12
Step 1: Shower Pan to Base
Insert the PC-000419 Uni-Seal into the hole at the bottom of
the shower sump. Place the shower pan on the base, with
the drain going towards the rear. Take the 2” drain pipe
supplied, and insert it through the hole in the rear of the
unit and into the Uni-seal in the bottom of the shower pan.
A lubricant, such as dish soap would help in getting the
pipe completely inserted into the uni-seal.
Step 2: Sidewall Panels to Rear Extrusions and Rear Wall Panel
Slide a plastic rear extrusion onto each side of the rear
panel making sure that the mitered ends are towards the
top of the rear panel
(where the fl y screens are, and the
ribbed side of the extrusions are facing toward the outside
of the shower).
Line up the holes in the rear extrusions
with the holes in the rear wall panels. Insert awls into the
center holes. Slide the right side wall panel
(with hatch in
corner
) into the corresponding slot of the rear extrusion
and remove the awl from that rear extrusion. Line up all
of the holes and rivet from the inside, the rear extrusions,
rear wall panel and side wall panel together using small
fl ange, rivets, PC-000104.
DO NOT RIVET THE TOP HOLE
IN EITHER OF THE EXTRUSIONS AT THIS TIME.
Remove
the awl in the left extrusion and rivet together the left side
wall panel, left rear extrusion, and rear panel, leaving the
top hole for later.
Right Side
Rear Panel
Right Rear Extrusion
PC-000104 Rivet
PC-000104 Rivet
(16) Used in this step
