PSW1-1000 - HandStand
December - 2010
Page 3 of 4
Parts Drawing - Exploded View
Soap Dispenser
Open the soap dispenser by placing your hands on both sides of the
dispenser and pressing up on the tabs of the lid. Locate the tab on
the mounting plate at the rear of the dispenser and push in on it and
slide the dispenser up and off . Fill with 30 fl uid ounces of liquid soap.
Refasten it to the mounting plate and snap the lid back on.
Paper Towel Dispenser
The dispenser is designed to accept single or multi fold, as well as roll towels. The
recommended towels are the
Georgia Pacifi c #23504 -
single fold or the
Baywest Ecosoft
#46200
- roll towel.
NOTE: When using other towels, be sure the width does not exceed
9-1/2”. The use of a roll towel complies with ADA requirements.
Emptying Fresh Water
Drain the fresh water by unscrewing the 1/2” plug located at the bottom of the sink.
Tighten the plug when fi nished.
Emptying Gray Water
Wheel the sink to a proper drain location such as a toilet or drain. Pull the hose out from
the rib on the back of the holding tank, remove the hose cap and empty the gray water.
Replace the cap when fi nished.
LS04-0001 Soap
Dispenser
(3) PC-000105 - Rivet
(3) PC-000106 - Washer
TD04-1000 - Paper Towel
Dispenser
(4) PC-000105 Rivet
(4) PC-000106 Washer
PC-000550 3” Gray Plug
PSW1-0001P
- Wash Stand W/Wheels Tank
PC-000377
- 3/4” Garden Hose Cap
PC-000313
- Rubber Hose Washer
PC-000376
- Fitting 1” x 3/4” MGHT
PC-000352
- Hose Clamp
CH100-0435
1”I.D. x 43.5” Long
PC-000352 - Hose Clamp
PC-100316 - Elbow
1” Barb x 1” Barb
PC-000417 - 3/4” Uni-Seal
PC-000417
3/4” Uni-Seal
(Replaces the 1/2”
spinweld fitting
and elbow in
previous models)
PSW1-0021 - Axle
PC-000213 - Wheel,
Rubber Tread
PS02-1000
Wash Stand Complete
(2) PC-000158 - Screw
