LED
LED
Timer
Function
FUNCTIONS
1. Press
to select from the 10 preset shows in the follow sequence or to turn off the lights.
Show #1: Steady Glow
Show #2: Multi-speed Fading
Show #3: Multi-speed Blinking
Show #4: Chasing
Show #5: Shooting Star
Show #6: Stacking
Show #7: Sparkle
Show #8: Cross Wave
Show #9: Alternating
Show #10: Combo
OFF: Press once after Show #10 to turn off the lights.
* If you unplug and reconnect the product to the power outlet, the product will
replay the last show that was playing before cutting out the power.
NOTE: To get the full effects of Shows #4-10, make sure all four of the outlets
are plugged and are in use.
2. Press
to select from the 4 preset timer settings:
a. Setting 1: Lights ON for 4 hours and then OFF for 20 hours (LED indicator on Light Wizard will be Green).
b. Setting 2: Lights ON for 6 hours and then OFF for 18 hours (LED indicator on Light Wizard will be Blue).
c. Setting 3: Lights ON for 8 hours and then OFF for 16 hours (LED indicator on Light Wizard will be Red).
d. Setting 4: TIMER OFF (LED indicator on Light Wizard will be Yellow).
* The LED light on the remote control will blink 5 times in red before turning off when "Timer off" setting is selected.
3. The timer will reset after each Show/Timer selection, and after you unplug and reconnect the product to the power outlet.
MAINTENANCE
• Insert batteries with correct polarity (+/-).
• Use ONLY AAA size (LR03) batteries.
• For longer battery life, use alkaline batteries.
• WARNING: CHOKING HAZARD - AAA BATTERIES ARE SMALL PARTS,
KEEP AWAY FROM CHILDREN.
• Do not expose light set to moisture.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (Carbon - Zinc), lithium, or rechargeable
(NiCd, NiMH or other type) batteries.
• Remove batteries when not used for an extended period of time, or when depleted.
• Dispose of used batteries properly.
• Dry wipe with a cloth to clean the battery contacts prior to battery installation.
• DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.
WARNING:
1. To place/replace batteries, open the cover.
2. Insert two AAA-size batteries (not included) into the compartment.
3. Close the cover.
Battery Replacement
Battery Cover
2 x AAA batteries (not included)
Fuse Replacement:
1. Grasp the plug and unplug the product from power. Do not unplug by pulling on the cord.
2. Slide open the fuse cover and remove the blown fuse carefully.
3. Insert the included spare fuse.
Risk of fire: replace only with 10 Amp 125 Volt fuse provided with the product.
4. Close the fuse cover.
SPARE FUSE
10A
OWNER′S MANUAL
3
