7
5
6
1. Set up the pool by following all instructions that come with the pool. Do not
fill water until the Filter Pump is properly installed. Locate the Outlet and
Inlet openings on the pool wall.
3. Install the return fitting on the Inlet opening of the pool.
2. Install the Suction Fitting on the outlet opening of the pool.
4. Remove the Filter Pump , Hoses , and Hose Clamps from
the package.
SETUP INSTRUCTIONS
WARNING:
POSITION THIS PRODUCT AWAY FROM THE POOL, SO AS TO PREVENT CHILDREN FROM CLIMBING ON IT AND ACCESSING THE POOL.
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
• All electrical components must be installed in accordance with standard NFC 15-100.
• CAUTION: All filters comply with the installation standard NF EN C 15-100, stipulating that any electrical device situated less than 3.5 metres from the pool and
which is freely accessible must run on low-voltage 12V power. Any electric device powered by 220V must be situated more than 2 metres from the edge of the pool.
Contact the manufacturer regarding any modifications to one or more parts of the filter system.
7
5
6
7
1
3
1
2
Inlet
Outlet
8. Do not plug in the filter pump at this point. Begin to fill water until the water
level reaches the fill line.
5. Connect the Hose
5
form the Suction Fitting
6
to the Filter Pump
Inlet.
6. Connect the Hose
5
form the pool Return Fitting to the Filter Pump
outlet.
7. Tighten all Hose Clamps
6
to prevent water leakage.
9. Air is now trapped inside the Filter Pump system, which will prevent the
water from flowing smoothly. To VENT the system (release the trapped
air), open the Vent Screw
8
at the top of the pump by turning it
counter-clockwise. The water pressure will force out all the trapped air
inside the Filter Pump system. Tighten the Vent Screw
8
when you see
water flowing out from the Seal Top
10
.
10. Adjust the Flow Diverter
3
to maximize the circulation of the
pool water.
5
6
5
6
10
8
10
8
3
10
11
OWNER’S MANUAL
