SoundStation2W™ User Guide - 23
Standby Mode
The phone has an automatic power save
function to extend battery operated usage.
The product will switch into Standby
within one minute of being in an idle
inactive state. The console will not go into
Standby if there is an active call, even if
there are pauses in the conversation.
If the console is registered to the base
station, and the phone goes into Standby
mode, the LCD will display a “READY”
message.
The console will switch into Standby
mode even when it is not registered to the
base station. In the case where the console
isn’t registered to the base station and goes
into Standby, the LCD will display a “NO
SIGNAL” message.
Any key press will “wake” the phone up.
All features of the phones are instantly
available by pressing the normal key
sequences. Incoming calls and paging
also functions normally while the phone
is in Standby, and will switch the phone to
active use mode.
►
Standby mode saves power but is
not an “Off” function. If you want
to fully turn the unit off, unplug the
battery.
►
While in Standby mode, the LCD
display will still show estimated
remaining talk time. Talk time is shown
numerically in hours to the right of the
battery icon.
►
The console will switch into Stand-
by, even if it is not registerd to the base
station. For example, if you travel with
the phone to a remote location without
the base station, the console will switch
into Standby to conserve power.
►
The console will automatically re-
register to its base station from Standby
mode, if it is within range and the base
station is powered.
►
In some cases, the phone will not
go into Standby mode when a mobile
phone is plugged in, even if the mobile
phone is not in an active call. In these
cases the LCD message will continue to
say “Mobile Phone In”. Either turn off
the mobile phone, or unplug it from the
console to enable Standby.
►
The phone will not go into Standby
while charging.
