KIRK Wireless Server 500 with CLIP – User Guide - 14096500-HD, Ed.8
14
01
:2
64
6.0 Radio Signal Checking – (Deployment)
Test display
To start the deployment, power up the KIRK Wireless Server 500.
As mentioned in 5.0 you will have to move around in the area with a KIRK Handset in special
“testing mode” to be covered when deploying as well as listening to the audio quality of the
handset.
The KIRK Handset (subscribed to the KIRK Wireless Server 500) has to be used for checking the
signal strength and quality being received securing proper handover.
Measuring the radio coverage can be done the following way.
The values to be checked are the Q-value and the RSSI-value whilst moving away from the KIRK
Wireless Server 500 and/or the KIRK Repeater(s).
To start deploying, dial
*99989*
and
press
√
- and go
OFF-HOOK.
Please note that
the handset has to be subscribed to the system before starting deploying (Please
refer to section
4.5
) and the handset has to be in OFF-HOOK mode.
RPN:
is the
alternative
repeater or the KIRK Wireless Server 500
4
number, e.g. repeater no. 02 or
repeater no. 03.
RSS:
refers to the
signal strength
(RSSI) from either the alternative KIRK Repeater or the KIRK
Wireless Server 500.
:
the number indicates the
actual
number of the KIRK Wireless Server 500 or KIRK Repeater
that the KIRK Handset has connected to. Please note that the KIRK Wireless Server 500 always
has number 01.
:
refers to the
speech quality
(BIT ERROR RATE) of the signal received from the KIRK
Wireless Server 500 or the KIRK Repeater.
Only the speech quality of the active connection is shown. Optimum level is 64 and should not be
less than 52.
Be aware that this value has to be
stable
(not fluctuating).
: RSSI -
refers to the
signal strength
from the actual KIRK Repeater or the KIRK Wireless
Server 500 to which the KIRK Handset is connected. You will find the
RSSI maximum level
by
4
The value of the Wireless Server KIRK 500 is always 01.
RPN: 02 03 04
RSS: 96 72 65
01 64 :2 140
