PO Box 409 • Hanover, MD 21076 • Tel (410) 761-4000 • www.polyplanar.com
- 6 -
Connecting the MZ-100 Input (Fixed Gain):
For operation without the optional external volume control, connect the amplifier
inputs to the VARIABLE LINE OUT of your receiver using shielded RCA patch
cables. In this case the amplifier volume will be determined by the volume setting
of the source component.
Connecting the MZ-100 Input (Variable Gain):
For operation with the external volume control, connect the amplifier inputs to the
PRE-AMP LINE OUT of your receiver using shielded RCA patch cables. The
Pre-amp line output should be a fixed level output that is independent of the
volume setting of the receiver.
To VARIABLE line output of receiver, TV,
or other audio source.
Figure 4 - Input connections without Volume control
Figure 5 - Input connections with Volume control
Volume
Control
NOTE:
The BLUE remote wire
should be switched or
connected to an
accessory circuit
NOTE:
The BLUE remote wire should be tied to
12V (Red wire). The amp can be turned
off by turning the volume knob all the
way down.
