E
E
N
N
G
G
L
L
I
I
S
S
H
H
71
LECOASPIRA INTELLIGENT
M
M
A
A
N
N
U
U
A
A
L
L
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
E
E
• Press the main switch (
1
): the appliance will
come on in manual or “MA” mode.
In this mode you can manually adjust the
amount of steam to be dispensed and the suc-
tion speed.
STEAM
• Press UP (
4
) to turn on the boiler. Each time
you press the UP button (
4
) again steam
pressure will increase. Every time you press
the UP button (
4
) one of the steam pressure
indicator lights (
8B
) will come on.
• DOWN (
5
) has the opposite effect: every
time you press it steam pressure decreases
and one of the indicator lights (
8B
) goes off.
• If you wish to turn off the boiler, press DOWN
(
5
) until all the indicator lights (
8B
) go off.
Strong steam: (4 indicators on)
to remove stubborn deposits, stains and
grease or to sanitise;
Normal steam: (2 or 3 indicator lights on)
for rugs, carpets, glass, floors;
Gentle steam: (1 indicator light on)
to spray plants, clean delicate fabrics, wallpa-
per, sofas, etc.
• When the boiler comes on the indicator lights
(
8B
) and (
8F
) will flash. When the boiler indi-
cator light (
8F
) stays on, this means the ap-
pliance has reached the minimum pressure
for dispensing steam. Wait until the other in-
dicator lights (
8B
) also stop flashing, mea-
ning that steam pressure has reached the
selected pressure.
• Press the Steam request button (
A5
) on the
handle to dispense steam.
Indicator light (
8D
) comes on when steam is
being dispensed.
SUCTIONING
You may adjust suction power to suit the sur-
face to be cleaned: the numbers correspond to
segments in the indicator light (
8C
) on.
1 for curtains
2 for sofas and cushions
3 for carpets
4 for hard floor surfaces and to suction up liq-
uids
Using suction controls
Simply press the suction button (
A4
) to start
vacuuming.
Hold down the suction button (
A4
) to select
the appropriate speed for the surface to be
cleaned. As suction power increases, the
number of indicator segments lit up will
increase (
8C
); as suction power deceases the
number of segments will decrease.
To stop vacuuming while the appliance is
turned on, simply press the suction button
(
A4
).
NOTE:
When you start suctioning, the appli-
ance starts vacuuming at the speed it was set
to when it was last turned off.
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
E
E
P
P
1
1
:
:
R
R
U
U
G
G
S
S
/
/
C
C
A
A
R
R
P
P
E
E
T
T
S
S
• Connect the two extension tubes (
D
) to the
handle, and connect the multipurpose brush
(
E
) to them with the carpet attachment with
rigid inserts (
E4
).
• Wait until indicator lights (
8B
) and (
8F
) stop
flashing. At this point the appliance is ready
to dispense steam.
• Hold down the Steam request button (
A5
) to
dispense steam. When you release the but-
ton (
A5
) or after a maximum of 150 seconds
suctioning will start automatically to dry the
steam-cleaned surface.
• Suctioning automatically stops after an
amount of time proportionate to the amount
of time for which steam was dispensed. You
may stop the programme manually by pres-
sing the suction button (
A4
).
• When cleaning large surfaces, you may start
up the programme immediately upon com-
pleting the cycle to finish cleaning the entire
surface.
NOTE:
suction speed and steam quantity are
preset and cannot be adjusted manually.
Vacuum up hair and dust in manual (
MA
) mode
before steam cleaning surfaces.
P
P
R
R
O
O
G
G
R
R
A
A
M
M
M
M
E
E
P
P
2
2
:
:
P
P
A
A
R
R
Q
Q
U
U
E
E
T
T
• Hold down the Steam request button (
A5
) to
dispense alternating steam cycles and start
suctioning. Release the button (
A5
) to stop
dispensing steam, while suctioning will conti-
nue for a few more seconds to allow the
steam cleaned surface to dry.
•
To avoid damaging delicate surfaces, we
LECOASPIRA INTELLIGENT - M0S09096 2Q03:Layout 1
04/03/2010
10.41
Pagina 71
Summary of Contents for VAPORETTO LECOASPIRA INTELLIGENT
Page 1: ...Fi Fi Fi Fi Fig...
