main steadily lit. For correct use of the suc-
tion read the section “Suction
control/switching off”.
Operation with steam only
• Press the main switch (
1
), the first level of the
suction indicators (
5
) will start to flash.
• Press the water boiler - terracotta/parquet
button (
2
) once only.
• The pressure indicator light (
4
) will flash un-
til the boiler reaches working pressure, then
stay on steadily. When it does the Va-
poretto Lecoaspira will be ready to generate
steam.
• You may now deliver steam by pressing the
steam button (
A5
) on the handle.
• If you decide not to use steam any more,
you can turn off the water boiler by holding
down the terracotta/parquet button (
2
) until
indicator lights (
2A
) and (
4
) both go out.
T
T
e
e
r
r
r
r
a
a
c
c
o
o
t
t
t
t
a
a
/
/
p
p
a
a
r
r
q
q
u
u
e
e
t
t
f
f
l
l
o
o
o
o
r
r
f
f
u
u
n
n
c
c
t
t
i
i
o
o
n
n
The parquet function is intended for cleaning
parquet and other delicate floor surfaces. This
function uses the combined action of a gentle,
intermittent jet of steam with vacuuming po-
wer at an appropriate level. When cleaning
delicate surfaces, always use it with the spe-
cial cloth with velcro (
E6
) provided applied to
the multipurpose brush (
E
).
• Press the main switch (
1
). The first level on
the vacuum indicator lights (
5
) will begin to
flash.
• Press the water boiler - terracotta/parquet
button (
2
) once only.
• The pressure indicator light (
4
) will flash un-
til the water boiler has reached working
pressure, then stay on steadily.
At
this
point, press the terracotta/parquet button
(
2
) again to turn on the parquet function; the
indicator light will come on (
2A
).
• While holding down the steam button (
A5
),
steam will be released alternately and va-
cuuming will begin at intermediate speed
(you cannot change vacuum speed). If you
release the button (
A5
), the steam supply
will be stopped, while vacuuming will conti-
nue for about 4 seconds more to dry the
surface treated.
• Press the button (
2
) again to stop working.
•
To avoid damage to delicate surfaces, al-
ways use the parquet function with the
multipurpose brush (E) wrapped in the
cloth with velcro (E6).
• Always be very careful when cleaning woo-
den surfaces (furniture, doors, etc.) and
treated terracotta floors, as prolonged use
of steam could damage the wax, polish or
colour of the surfaces.
L
L
A
A
C
C
K
K
O
O
F
F
W
W
A
A
T
T
E
E
R
R
I
I
N
N
T
T
H
H
E
E
B
B
O
O
I
I
L
L
E
E
R
R
Lack of water in the boiler will be shown by the
indicator lamp (
3
) and you will also be warned
by an audible signal.
In order to continue working, it will be suffi-
cient to proceed as described in the section
“PATENTED SAFETY CAP”.
P
P
A
A
T
T
E
E
N
N
T
T
E
E
D
D
S
S
A
A
F
F
E
E
T
T
Y
Y
C
C
A
A
P
P
This appliance is equipped with a patented sa-
fety cap, which prevents opening of the
generator tank as long as there is any pres-
sure remaining inside the tank. This is an im-
portant and indispensable safety device and it
is necessary to follow certain procedures
when re-filling the tank.
When you have used up all the water in the
tank, follow the following procedures:
• Press the terracotta/parquet button (
2
) until
both indicator lights (
2A
) and (
4
) go out.
• Press the steam request button (
A5
) on the
hand gun or the steam request button (
X
)
on the iron (
W
) so as to fully exhaust the
steam supply from the tank.
• Disconnect the power supply cable (
13
)
from the mains.
• Unscrew the safety cap (
7
) anti-clockwise.
• Wait for a few minutes to allow the genera-
tor tank to cool down.
• To refill the boiler follow the instructions in
the paragraph headed PREPARING THE
APPLIANCE FOR USE.
WARNING:
When filling the water boiler when
it is already hot, we strongly advise you to
SLOWLY AND CAREFULLY add just a little
water at a time to avoid steam blowback from
the aperture.
LECOASPIRA 705
57
E
E
N
N
G
G
L
L
I
I
S
S
H
H
LECOASPIRA 705 - M0S07835 1N03:Layout 1 20/04/2007 11.40 Pagina 57
