POLTI VAPORELLA NEXT VN18.10, Instruction Manual

Page: 27 / 80

17. TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Water comes out of the
iron instead of steam
Temperature dial is
turned to minimum value.
Check that the iron temperature
adjustment dial is set to
medium/high.
When first switched on. Emit onto a cloth until steam
comes out of the holes in the plate.
Steam does not come
out of the iron.
No power. Make sure that the appliance is
connected to the mains and the
switch is on.
Water reservoir empty. Fill the water tank.
Little steam comes out
of the iron.
The steam is dry and not
very visible, but present
and effective.
This is a normal phenomenon seen
in particular environmental
conditions.
The appliance does not
turn on.
Switch off or flashing. Press the switch and make sure
that the appliance is connected to
the mains.
Traces of water remain
on the garments.
The ironing board cover
is saturated with water as
the board is not suited to
the power of an iron with
a boiler.
Check that the ironing board is
suitable (a board with a mesh top
that prevents condensation).
Water under the
appliance.
Boiler cap screwed on
incorrectly.
Unscrew the boiler cap and screw
it back on (section 13).
Seal of the boiler cap
damaged.
Replace the damaged seal (section
14).
If problems persist or are not listed above, please contact a Polti Authorised Service Cen-
tre (www.polti.com for the updated list) or contact Customer Services.
E
N
G
L
IS
H
| 27 |