IK-E366-001
5
4.
STRUCTURE DESCRIPTION.
Figure 1 The detector after removing the cover.
Figure 1 shows the interior view of the detector. The detector is equipped with two installation
connectors that allow the use of cables such as wire or cord with a cross-section of 0.25 to 2.5 mm
2
.
These connectors are used to connect the power supply and the detector signalling outputs. The
second connector has the same function, which enables the user to connect another detector without
the need for a junction box.
Markings related to the power contacts are located on the sticker between the connectors and are
presented in the table below.
TEST button
TEST button
Gas sensor module
Sensor cover
Jumper for selecting the
A3/FLT output function
Jumper for selecting the
common contact function
Power terminals and signal
outputs
