24
Push the mode button again to access the priority memory channel display. To priority
scan, press the arrow key. The unit will now scan between the memory channel and
priority channel.
d.
Push the mode button again to access the program page.
e.
7 External memory toggle
This button alternately replaces an active frequency and the standby frequency.
6.3 Memory programming
The top line should read memory channel 1 (1 to 32 and PRI).
Select the required memory number with the up/down dial.
Next push the dial to select the bottom line MHz.
Now enter the desired frequency.
Push the dial again to enter the kHz and adjust.
Next push the arrows button, the memory number will flash then programmed will ap
-
pear. You now have a programmed memory channel.
Repeat this operation for other memory channels.
Up to 32 channels can be programmed.
Only programmed channels will be displayed.
By programming a frequency into Memory “PRI” this will give you a priority selection.
6.4 Memory delete
1 The top line should read memory channel 1 (1 to 32 and PRI).
2 Select the required memory number with the up/down dial.
3 Push the “PRI” button, the memory channel is deleted.
6.5 Operation of intercom
Internal adjustment of the sidetone volume may need to be done to set the correct level.
In a noisy environment reducing the microphone gain may also be required.
Do not adjust the modulation!!!! A wind sock over the mike will also help reduce noise.
The VOX operation can be used and sensitivity can be set in the user setting mode.
Note: VOX (Voice operated Transmission)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1.
2.
3.
