UMC1
7
BASIC OPERATION
Power On/Off
Press and hold the
Power
button (1) to turn the unit on/off.
Volume
To increase the volume, rotate the
Encoder Knob
(3) clockwise. To decrease the
volume, rotate the
Encoder Knob
counter-clockwise.
Play/Pause/Mute
Press the
►||
button (8) on the control panel to pause or mute the audio output.
Press
►||
button again to unmute or resume the audio.
Mode
Press the
Mode
button (9) on the control panel to enter mode selection display.
Rotate the
Encoder Knob
(3) to page through the available playback modes.
Press the
Encoder Knob
to enter the desired playback modes.
Audio Settings
Press the
Menu
button (2) on the control panel to access the audio settings. You
can navigate through the audio settings menu items by rotating the
Encoder
Knob
clockwise or counter-clockwise, and then press the
Encoder Knob
to make
selection. The unit will automatically exit the audio menu after 10 seconds of
inactivity. The following menu items can be adjusted.
Bass Level
Use the
Encoder Knob
to adjust the Bass level range from “-6” to “+6”.
Treble Level
Use the
Encoder Knob
to adjust the Treble level range from “-6” to “+6”.
Balance
Use the
Encoder Knob
to adjust the Balance between the left and right speakers
from “L12” (full left) to “R12” (full right).
Fade
Use the
Encoder Knob
to adjust the Fader between the rear and front speakers
from “R12” (full rear) to “F12” (full front).
Sub
Use the
Encoder Knob
to adjust the Sub level range from 0 to 40.
Loudness
Press the
Loud
soft
button (4) to toggle loudness on/off. When listening to music
at low volumes, this feature will boost the bass and treble ranges.
Zones
The unit connects to UM2DSP using JDAB 4PIN. When Zone Toggle is On, Zone
Settings and SUB volume are adjustable (default at 20). Press the
Menu
button (2)
on the control panel to access the audio settings menu, and then press the (6)
button to enter Zone Settings. Rotate the
Encoder Knob
to select Zone 1-4 and
then press the Encoder Knob to enter a Zone. Rotate the
Encoder Knob
to adjust
Zone volume. Press the
Encoder Knob
again to confirm the volume level.
Profiles
Press the (5) button to enter Profile Settings: Drive, Chill, Tow-Wake, Tow-Surf,
Tow-Ski.
Summary of Contents for UMC1
Page 1: ...UMC1 Installation and Operation Manual...
Page 8: ...UMC1 6 WIRING...
