Politec SANDOR HYBRID SMA, Technical Manual

Page: 2 / 20

POLITEC s.r.l. | Manual Sandor HYBRID SMA – Ver. 1.2 2
INDEX
1 MAIN COMPONENTS Pag. 3
2 MOUNTING SAMPLES Pag. 4
MOUNTING WITH BRACKETS Pag. 5
3 INSTALLATION SAMPLES Pag. 6
4 WIRING Pag. 7
5 CONFIGURATION OF THE OPTICALS Pag. 8
OPTICAL TX Pag. 8
OPTICAL RX Pag. 9
6 SANDOR WS SMA TX MOTHER BOARD Pag. 10
7 SANDOR WS SMA RX MOTHER BOARD Pag. 11
8 SETTINGS & FUNCTIONS Pag. 12
DIP SWITCHES Pag. 12
9 COLOUMN ALIGNMENT Pag. 13
10 CALIBRATION WITH SMA SYSTEM Pag. 14
11 PARALLEL BEAMS CALIBRATION Pag. 18
12 ALARM SENSITIVITY ADJUSTMENT Pag. 19
13 TECHNICAL CHARACTERISTICS Pag. 20
Installation recommendation

Verify that the beam tower is fully watertight once the cover and end caps have been correctly filled at the
end of the installation.

Use the cable glands supplied on the tower for all cabling must pass through the lower end cap using the
cable glands supplied. The missed used of proper accessories decrease the IP grade protection of the
tower.

Avoid any type of obstruction between the transmitter and receiver.

Avoid installing the receivers beams in a position where direct sunlight, at the same angle as the receivers
beams, can enter directly into optics especially at sunset and sunrise

Do not install multiple beams where the transmitter beam can interfere with other receiver beams. It is
always better place either transmitter or receivers back to back.