30
SANDOR PLUS SMA
POLITEC | INSTALLATION MANUAL - VER.2.6
By default, the columns supplied with 3 +3 or 2 +2 total beams are set during the factory testing
phase.If it is necessary to change the original number of Beams in the field, DIP SWITCH 6 or 7 must
be set to ON on the 12 unit of the MES9012 motherboard, as shown below:
18.1 Setting of models with 3 Beams
The DIP SWITCH setting on the optics in the column is set as follows:
ON
RX3
ON
RX2
ON
TX2
ON
TX3
ON
RX4
ON
TX4
1 2 3 4 5 6 7
1 2 3 4 5 6
1 2 3 4 5 6 7
1 2 3 4 5 6
18.2 Setting of models with 2 Beams
The DIP SWITCH setting on the optics in the column is set as follows:
Set to ON DIP 7 of the 12 unit on the MES9012 motherboard Receivers side to exclude RX1
Set to ON DIP 6 of the 12 unit on the MES9012 motherboard Receivers side to exclude RX1 + RX2
18.Appendix C: 3TX +3RX or 2TX +2RX configuration
1
2 3 4 5 6 7 8 9 10 11 12
ON
1
2 3 4 5 6 7 8 9 10 11 12
ON
ON
RX3
ON
TX3
ON
RX4
ON
TX4
1 2 3 4 5 6 7
1 2 3 4 5 6
1 2 3 4 5 6 7
1 2 3 4 5 6
