Polestar 2 2020, Manual

Page: 357 / 568

Opening and closing
the charging input
socket hatch
The flap for the high voltage battery's charging
input socket is opened manually.
Press in the rear section of the cover and
release.
Open the cover.
Close the cover for the charging input socket in
reverse order.
Related information
• Start high voltage battery charging (p. 357)
• Stop high voltage battery charging (p. 367)
• Charging the high voltage battery (p. 349)
Start high voltage
battery charging
When charging with alternating current, only
use the charging cable supplied with the car or a
replacement cable recommended by Polestar.
The car's high voltage battery is charged with a
charging cable between the car and a 230 V
socket
134
(alternating current) or charging sta-
tion (mode 3).
Take out the charging cable. Note that the car
must be switched off prior to charging.
Connect the charging cable to a 230 V
socket. Never use an extension cable.
Set the correct charging current (for exist-
ing 230 V socket) in the centre display.
Open the charging hatch. Remove the
charging handle's protective cover and
make sure there are no objects in the charg-
ing input socket that could prevent charg-
ing.
Then press the handle the whole way into
the socket for the car.
134 The voltage in the socket may vary depending on market.
>>
Electric operation and charging 357