PS-4600TW
Guide d’installation
P. 7
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Multi car operation
Level 3
(requires pressing the
SHIFT
button 3X)
Æ
Customized
features
Option 3:
Level 1
(requires pressing the
SHIFT
button 1X)
Æ
Customized features
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Multi car operation
Level 3
(requires pressing the
SHIFT
button 3X)
Æ
Basic features
Option 4:
Level 1
(requires pressing the
SHIFT
button 1X)
Æ
Basic features
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Customized
features
Level 3 (
requires pressing the
SHIFT
button 3X)
Æ
Multi car operation
Example: If the multi-level features were set to option 3, the setup would be as follows:
x
Level 1
Æ
Customized feature
x
Level 2
Æ
Multi car operation
x
Level 3
Æ
Basic
features
The “Basic features” are now programmed as level 3 and therefore:
x
To access the aux.2 feature, the user needs to press on the
SHIFT
button three (3) times
followed by the
LOCK
button.
x
To access the status request feature, the user needs to press on the
SHIFT
button three (3)
times followed by the
TRUNK
button.
x
To access cold weather mode, the user needs to press on the
SHIFT
button three (3) times
followed by the
START/STOP
button.
Remote-Starting Your Vehicle
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
to inform you
that the remote starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain
ON
during the pre-programmed run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm and unlock the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
position. (Do not turn the key to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
