User guide
P. 7
If your system is equipped with the 2
nd
generation remote:
Press and hold the
STOP
button for more than 3 seconds until the sound signal starts and the
parking lights flash.
If your system is equipped with the 1
st
generation remote:
In an emergency situation, you can activate Panic Mode using the
LOCK
or
UNLOCK
button. This will:
•
shut down the engine,
•
unlock the doors (with the
UNLOCK
button)
•
or lock the doors (with the
LOCK
button),
•
disarm the Starter Kill and
•
activate the horn for 30 sec.
To activate Panic Mode:
Press and hold the
UNLOCK
or
LOCK
button for approximately 3 sec. until the sound signal
starts and the parking lights flash: this will unlock or lock the doors accordingly before
the sound signal starts.
Panic Mode will automatically shut down after 30 sec.
Note
:
To stop Panic Mode before the end of its delay, press the
LOCK
or
UNLOCK
button until
the sound signal stops.
Quick Lockout
TM
(Also called
Secure Panic
.) For fast protection in emergency situations, the system will
LOCK
all
doors when you
press the brake pedal while you hear the sound signal
. (
Quick Lockout
is
only available when
Panic Mode
has been set off.)
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for
3
minutes (or for
8
or 20 minutes with diesel engines). Cold Weather Mode automatically ends after 24 hours.
To enter Cold Weather Mode:
Press and hold the
START
button for 3 seconds until the parking lights flash three times.
To exit Cold Weather Mode, do any one of the following actions:
Open the hood.
Start the engine by remote.
Turn the ignition key to the
IGNITION ON (RUN)
position.
Press and hold the
START
button for 3 sec.
(the parking lights will flash once)
.
If Safe Start is enabled, you can activate Cold Weather Mode by
Pressing and releasing the
START
button, then
Pressing and holding the
START
button until the Parking Lights flash 3 times
Extended Run Time
With the vehicle running under a remote start, pressing and holding the
START
button for more than
1 second will reset the run time counter to zero and restart the run time cycle from the beginning.
To stop the vehicle, at any moment, simply press the
STOP
button. This procedure can only be
carried out once per remote start.
Example:
if your Module is programmed for a run time of
3
minutes and your vehicle has been
running for
2
minutes already, pressing the
START
button will reset the counter to zero and the
Engine will run for another cycle (in this case,
3
minutes).
Advanced Features: Installation-programmable Options
The Remote Car Starter was designed with flexibility and OEM integration in mind. With its
programmable options, this unit can single-handedly control nearly any electrical system in your
vehicle.
