Polaroid SprintScan 45, Hardware Manual

Page: 4 / 33

Use this guide as a quick reference for scanning. For details,
see the pages indicated.
See page:
2-6 1 Install a SCSI host adapter card in your computer
(PC-compatibles only).
2-5
2
Change the SCSI ID number of the scanner, if necessary. The
factory setting is 5.
2-6
3
With all equipment turned off, connect the scanner to your
computer using the SCSI cable provided. If the scanner is the
last device in the chain, use a terminator at the scanner.
2-9
4
Plug the power cable into the scanner and into a grounded
power outlet.
2-9
5
Turn on the scanner, then your computer.
––
6
Install the software according to the software manual.
2-10–2-13
7
To scan an image, place the transparency or negative in one of
the carriers, using an adapter for formats smaller than 4x5
inches.
2-14 8 Lift the carrier access door and insert the loaded carrier into
the front slot.
––
9
Initiate the scan from the software (see the software manual).
When the scan is complete, pull out the carrier. Remove the
original transparency or negative, and store it properly.
Quick Scanning Guide iii
Quick Scanning Guide