36
Auto Code Search Setup
This method does not require use of the Device Code Table.
1 Turn the device power off and point the Polaroid Universal Remote Control at the device
you wish to control.
2 Momentarily press a device button on the Polaroid Remote Control (
TV, DVD, CBL
, or
AUX
). When you release the device button the red LED at the top of the remote will blink
once.
Note:
For devices other than a TV, DVD, or Cable Box, use the
AUX
key.
3 Press and hold the
SET
button (top-left button) until you see the LED blink once, followed
by two short blinks. Release the
SET
button after you see the two short LED blinks.
4 Press
9 - 9 - 1
on the number pad. Each time you press the number
9
button the LED
blinks
once
. When you press the number
1
button, the LED blinks
twice
.
5 Enter the following number, depending on the device you are trying to control. When you
release the button, you should see two short LED blinks.
Cable or Satellite box – Press
0
TV – Press
1
DVD player – Press
2
Audio device or VCR – Press
3
6 Momentarily press the power button (top-right button) and release it.
7 Press the
CH+
button, slowly and repeatedly, until the device you want to control turns on.
Stop pressing immediately when the device power turns on
.
Note:
If you press the
CH+
button too quickly you may save the wrong code, in which case
the remote control will not turn the device power on. Start at step 1 and repeat the
programming steps again.
8 When the device turns on, press and hold the
SET
button until you see the LED blink
twice
. The code is now saved, and the remote should operate properly.
