Polaroid Joshua Captiva, Service Manual

Page: 105 / 134

4 - 33
Main Frame (Gear Side - Outer)
1. Disassembly (Figure 4-42)
Note: If applicable, remove the Mirror Catcher.
a. Using a square drive, remove the six (6) screws that secures the Drive Cover to the Main Body
of the camera. Lift off the Drive Cover.
b. Using a solder aid stick, gently pry out the plastic locking tabs of the Outer Viewfinder Lens to
release it from the Drive Cover. Lift out the Outer Viewfinder Lens.
c. Using the applicable tool (dental pick, needlenose pliers, narrow blade flat screwdriver), remove
the following from the Main Frame:
• (1) Gear #4 (white plastic)
• (2) Clutch Gear
• (3) Idler Gear
• (4) 5-Wire Detail Switch Assembly (If necessary, gently pry up the 5-Wire Detail Switch
Assembly to release it from its plastic locating pin.)
• (5) Counter Return Spring
• (6) Inner Door Stop Link
• (7) Counter Wheel
• (8) Outer Door Stop Link
• (9) Carrier Spring (The Carrier Spring connects the Pick with the Counter Detent.)
• (10) Counter Detent
• (11) Door Stop
• (12) Pick Assembly
• (13) Recock Latch Spring
• (14) Recock Latch
• (15) Viewfinder Blind Assembly
• (16) Viewfinder Blind Over Travel Spring
• (17) Trim Slider
• (18) Re-cock Link Spring
• (19) Re-cock Link
• (20) Trim Detent
• (21) Inner Viewfinder Lens Clip
• (22) Inner Viewfinder Lens