101
MAINTENANCE AND LUBRICATION
Battery
Battery Storage
Whenever the vehicle is not used for a period of three months or more,
remove the battery from the vehicle, ensure that it’s fully charged, and
store it out of the sun in a cool, dry place. Check battery voltage each
month during storage and recharge as needed to maintain a full charge.
NOTE:
Battery charge can be maintained by using a Polaris Battery
Tender
t
charger (PN 2871076) or by charging about once a month to
make up for normal self-discharge. Battery Tender
t
can be left
connected during the storage period, and will automatically charge the
battery if the voltage drops below a pre-determined point.
Battery Charging
The following battery charging instructions apply only to the
installation of a YUASA activated, sealed battery. Read all
instructions before proceeding with the installation of this battery.
The YUASA activated, sealed battery is already filled with electrolyte
and has been sealed and
fully charged
at the factory.
Do not ever
pry
the sealing strip off or add any other fluid to this battery.
The single most important thing about maintaining a sealed battery is
to keep it fully charged. Since the battery is sealed and the sealing strip
cannot be removed, you must use a voltmeter or multimeter to measure
DC voltage.
For a refresh charge, follow all instructions carefully.
1. Check the battery voltage with a voltmeter or multimeter. A fully
charged battery will register 12.8 V or higher.
2. If the voltage is less than 12.8 volts, recharge the battery at 1.2
amps or less until the battery voltage is 12.8 or greater.
NOTE:
When using an automatic charger, refer to the charger
manufacturer’s instructions for recharging. When using a constant
current charger, use the following guidelines for recharging.
An overheated battery may explode, causing severe injury or
death. Always watch charging times carefully. Stop charging if
the battery becomes very warm to the touch. Allow it to cool
before resuming charging.
WARNING
