9926813 R04 - 2013-2016
RZR
570 Service Manual
© Copyright Polaris Industries Inc.
2.23
PVT / FINAL DRIVE / WHEEL AND TIRE
WHEEL AND HUB TORQUE TABLE
TORQUE
Wheel Nuts:
Steel Rims: 27 ft-lbs (37 Nm)
Aluminum Rims: 30 ft-lbs (41 Nm) + 90°
TORQUE
Hub Castle Nuts:
Front:
80 ft-lb (108 Nm)
Rear:
110 ft-lbs (149 Nm)
NOTE
Do not lubricate the stud or the lug nut.
WHEEL REMOVAL
1.
Position the vehicle on a level surface.
2.
Place the transmission in PARK (P) and stop the
engine.
3.
Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the cotter pin and loosen the hub
nut slightly.
4.
Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5.
Remove the wheel nuts and remove the wheel.
6.
If hub removal is required, remove the hub nut and
washers.
WHEEL INSTALLATION
1.
Verify the transmission is still in PARK (P).
2.
Install the wheel hub
q
, washers
w
, and hub nut
e
,
if previously removed.
3.
Place the wheel
r
in the correct position on the
wheel hub. Be sure the valve stem is toward the
outside and rotation arrows on the tire point toward
forward rotation.
4.
Attach the wheel nuts
t
and finger tighten them.
5.
Carefully lower the vehicle to the ground.
6.
Torque the wheel nuts and/or hub nut to the proper
torque specification listed in the torque table at the
beginning of this section.
7.
If hub nut was removed, install a
new
cotter pin
y
after the hub nut has been tightened and install dust
cap
u
.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered rear
wheel nuts, make sure tapered end of nut goes into
taper on wheel.