4. Select the file you wish to load (use date listed in the file name to determine
most recent file).
5. Select Yes to restart display (restart required).
ERROR MESSAGES
If an error occurs while updating your software, perform one or all of the
following actions to resolve the issue:
1. Remove and reconnect the USB flash drive securely.
2. Make sure the display files are not inside a folder on the flash drive.
3. Make sure only display files are on the flash drive. Remove any other files if
necessary.
4. Try using a different USB flash drive.
UPDATE MAPS
To update the maps on your display, do the following:
1. Go to
ridecommand.polaris.com/update
and download the map update to a
USB flash drive.
2. Insert USB flash drive into the USB port on your vehicle.
3. Press the Update maps in the General Settings.
4. Select the file you want to install by pressing the corresponding down arrow
icon.
5. This will update the display’s map which will automatically restart the display
once the update is complete. Do not remove the USB flash drive until the
display has fully restarted.
USB HARDWARE
SOFTWARE UPDATES
For software update, POLARIS recommends using a SanDisk® or similar USB
flash drive with a minimum of 4GB in available memory, formatted using the
FAT32 or exFAT® file systems. For best results remove all files from the flash
drive before starting the update process.
MAP UPDATES
For Map updates, a 32GB USB drive is required (USB 3.0 drive is highly
recommended) USB drive must be formatted to exFAT® before copying the map
file onto it.
TRAIL UPDATES
For Trail updates, a 4GB drive formatted to FAT32 can be used.
60
