Polaris PVCR 3000 Cyclonic PRO, Operation Manual, Page: 67 / 134

67
6. Installation of the bristle roller back to its place in the brush body shall be performed in the reverse manner. (Fig. 21)
7. Given a severe clogging of components of the brush and electric drive, contact an authorized service center for
disassembling and cleaning.
CLEANING THE LATERAL BRUSHES (Fig. 22)
1. Turn off the vacuum cleaner.
2. Check the brushes for any defects and / or foreign items, as well as debris having wound around.
3. If necessary, detach the brushes.
4. Wipe the brushes with a piece of cloth preliminary soaked in hot water and well wrung. Perform the cleaning each
time after vacuuming.
5. Given any damage to the lateral brushes, timely replace them.
CLEANING THE SENSORS AND CONTACT LEADS
- Make sure to keep the frontal and rear wheels free from debris accrual.
- Clean the ventilation port from dust: open the grid by rotating it clockwise by means of a coin, pry it up and take
out. Extract the foam filter, and clean it from dust by rinsing under fresh water without using any detergents. Dry it
out in the air without heating. Install the filter on its place and secure the lid. (Fig. 23)
- To remove dust from the fall sensors wipe them with a piece of soft cloth provided exertion no mechanical impact.
(Fig. 24)
- To remove dust from the bumper wipe it with a soft brush or a soft rag provided exertion no mechanical impact.
(Fig. 25)
- Use a piece of dry soft cloth to wipe the contact leads at the vacuum cleaner bottom, or on the base
- Disconnect the electric battery at a long-term idleness of the device.
Any works regarding cleaning external parts of the vacuum cleaner are beyond the warranty service.
TROUBLESHOOTING
The Table contains the most usual problems which may arise during operation the device.
# Problem
Indication
Elimination method
1 The left rear fall
sensor does not work E 001 Check the sensor for
contamination, remove any
obstacles or debris wound around.
Given no obstacles, contact ASC.
2 The left frontal fall
sensor does not work E 002 Check the sensor for
contamination, remove any
obstacles or debris wound around.
Given no obstacles, contact ASC.
3 The frontal fall sensor
does not work E 003 Check the sensor for
contamination, remove any
obstacles or debris wound around.
Given no obstacles, contact ASC.
4 The right frontal fall
sensor does not work E 004 Check the sensor for
contamination, remove any
obstacles or debris wound around.
Given no obstacles, contact ASC.
5 The right rear fall
sensor does not work E 005 Check the sensor for
contamination, remove any
obstacles or debris wound around.
Given no obstacles, contact ASC.
6 The right part of the
bumper gets stuck E 006 Check the bumper for sticking,
remove any contamination and
foreign items.