Instr 9927474
Rev 01 2017-02
Page 7 of 14
3. Secure all remaining wires to the vehicles main
wire harness as shown.
HANDLEBAR SWITCH INSTALLATION
1. Install the handlebar switch
q
using supplied
screws
P
on handlebar as shown. Torque screws
to the specification listed below being careful not
to overtighten..
TORQUE
2 ft. lbs. (2.7 Nm)
2. Connect handlebar switch connector
Q
to the
vehicle main wire harness as shown.
WIRELESS REMOTE HOLDER INSTALLATION
1. Wireless remote holder can be installed in desired
location on vehicle. Use the screws provided in the
wireless remote kit for holder installation. For your
reference see the photo below for possible
mounting location of wireless remote holder.
FINAL INSPECTION
1. Confirm all the wiring is correct.
2. Confirm that there are no exposed wires or
terminals.
3. All loose wires need to be wrapped tight and
secured away from moving parts and heat
sources.
