Instr 9927256
Rev 01 2016-07
Page 5 of 8
RZR INSTALLATION
1. Shift vehicle transmission into “PARK”. Turn key to
“OFF” position and remove from vehicle.
2. Gain access.
a. Remove hood.
b. Remove windshield, as applicable.
c. Remove seat to gain battery access.
3. Disconnect black negative (-) cable from battery.
4. Loosely route 4–pin end of harness
w
from under-
hood compartment rearward through firewall
grommet into upper dash compartment.
5. Install switch module.
a. Remove two screws
A
securing front of upper
dash panel, then carefully pull panel rearward,
disengaging seven retaining clips
B
as shown.
If necessary for access, label and disconnect
other electrical harnesses from control panel.
b. Carefully cut one rectangular switch blank from
upper dash panel.
NOTE
Any open location may be used.
c. Install switch module
q
to upper dash panel,
then connect 4–pin end of harness
w
to switch
as shown.
d. If other electrical harnesses were disconnected
in step a., reconnect them now.
e. Reinstall upper dash panel using two retained
screws
A
.
6. Install harness.
a. Drill out one accessory plug (1/4 inch) on
forward side of firewall, then install fuseholder
C
using attached fir tree clip as shown.
IMPORTANT
Control drill depth to prevent damage to underlying
structure or components.
b. Connect ring terminals to terminal block.
•
ORANGE
harness wire: To post with existing
ORANGE wire (with or without white stripe)
(accessory switched 12V POS); post may be
identified as “ACC”
•
BROWN
harness wire: To post with existing
BLACK battery connection cable (12V NEG);
post may be identified as “GND”
c. Secure harness as required to prevent contact
with hot components, sharp edges, or moving
parts.
7. Reconnect black negative (-) cable to battery.
8. Restore access.
