Instr 9927256
Rev 01 2016-07
Page 4 of 8
b. Carefully pull control panel away from main
dash panel. If necessary for access, label
and disconnect other electrical harnesses
from control panel switches.
c. Carefully cut or remove, as applicable, one
rectangular switch blank from control panel.
NOTE
Any open location may be used.
d. Route 4–pin end of harness
w
through
control panel and connect to switch module
q
, then install switch to panel. See FULL-
SIZE RANGER Step 5d. for similar
illustration.
e. If other electrical harnesses were
disconnected in step b., reconnect them now.
f.
Reinstall control panel.
6. Install harness.
a. Install fuseholder.
IMPORTANT
Control drill depth to prevent damage to underlying
structure or components.
•
FULL-SIZE RANGER:
On forward side of firewall, drill 1/4 inch hole
for fuseholder fir tree clip, then install
fuseholder
F
.
•
MID-SIZE RANGER:
Locate empty 1/4 inch hole near terminal
block for fuseholder fir tree clip, then install
fuseholder.
OPTIONAL: Remove fir tree clip from
fuseholder, then secure fuseholder to
structure using cable tie (not included).
•
GENERAL:
Drill out one accessory plug (1/4 inch) on
forward side of firewall, then install
fuseholder (location similar to FULL-SIZE
RANGER shown above).
b. Connect harness
w
ring terminals to terminal
block.
•
ORANGE
harness wire: To post with existing
ORANGE wire (with or without white stripe)
(accessory switched 12V POS); post may be
identified as “ACC”
•
BROWN
harness wire: To post with existing
BLACK battery connection cable (12V NEG);
post may be identified as “GND”
c. Secure harness as required to prevent contact
with hot components, sharp edges, or moving
parts.
7. Reconnect black negative (-) cable to battery.
8. Restore access.
