6
The wiring and installation of this unit requires special technical skill and experience. If you do
not feel confident installing this product or do not have the level of skill necessary, please
contact Polaris on 1300 555 514 so we can refer to a recommended installer.
This unit is designed to be used in a vehicle with a 12 volt battery and a negative grounding.
Before installing this unit to a recreational vehicle, bus, or truck, make sure the battery
voltage is appropriate for this unit to be used. If installing into a 24Volt vehicle , you will need
a 10 amp converter which can be purchased through automotive electronic shops such as
Jaycar electronics.
To avoid short circuit in the electrical system, ensure that the negative battery cable is
disconnected before installation.
To avoid possibility of shorting out the electrical circuit in the unit, never connect the battery
wire directly to the vehicle battery.
Always secure all wirings with cable clamps or adhesive tape to prevent short circuit.
Please make sure all wiring connections and speaker wires are well insulated.
When pulling the dash apart, please use quality trim tools to avoid damaging your dash.
Please do NOT cut any plugs off of any Polaris cameras. Doing so will void your warranty! If
you need to blend other brand cameras into our system, please call Polaris on 1300 555 514
so we can refer you to a recommended dealer who has the skill and experience in performing
this type of work.
If you want an aftermarket reverse camera to trigger when reverse gear is engaged, you will
need to find reverse power. Please see page 14 for aftermarket reverse cam wiring
instructions or page 4 For OEM reverse camera wiring instructions
If there is something you are not 100% sure about when installing this unit, please give our
experienced technicians a call on 1300 555 514.
You shouldn't be required the programme in the steering wheel controls as the power harness
has a canbus module built in. The canbus module is what controls the steering wheel control
functions so they should work from the get go provided that everything has been plugged in
correctly.
Installation Notes