-14-
STEERING LIMITER ADJUSTMENT:
11. Make sure the cable can slide in the
clamping blocks. Turn the vehicle’s
steering to its maximum point of
travel on the left hand side. Maintain
pressure on the bars and mark the
cable at a distance of 19 mm [3/4 in]
from the edge of the clamping blocks.
Repeat steps to adjust right side.
Figure 24.
Figure 24
CAUTION:
The track systems’ angle of attack must absolutely be set before beginning
steering limiter adjustment. Refer to the User Manual for angle of attack settings.
10. Position aluminium blocks of steering
limiter assembly at center hole of
bottom part of front anchor bracket.
Use bolt, washer and nut to secure
the assembly in the center of the
anchor bracket. Tighten nut through
central opening of top part to
37 ft. lbs. (50 Nm). Figure 23.
NOTE:
Bolt must be inserted through
the bottom of the assembly.
NOTE:
Step spacer must be installed
in aluminium block hole that faces
front of vehicle.
Figure 23
Figure 23a
Nut
Bolt
Washer
Front
Use this hole to assemble
Mark
19 mm [3/4”]
