Page 17
English
Problem
Cause
Solution
Cleaner stops up to 20
seconds during cleaning
cycle.
Cleaner is performing normal
calibration operation.
No user action required. The pause does not affect
the overall cleaning cycle.
Cable is tangling in the pool Too much cable length in the water.
Do not unravel the entire cable. Use only the
amount needed for the cleaner to cover the pool
area.
Place the remaining unused cable on the side of
the pool. Follow the procedure in
Cord Tangling
to
avoid and correct tangled cord.
The cleaner is not cleaning
effectively.
The brushes have become smooth or
the "wear" indicator shows.
Replace the brushes following the procedure in
Replacing the Brushes
.
Filter canister is full or dirty.
Clean the filter canister following the procedure in
Cleaning the Filter Canister
.
Floating cable is excessively coiled or
kinked.
Make sure the floating cable is spread out over the
pool. Ensure the cable is not too tightly wrapped
or coiled when storing. If the problem persists, lay
the cable straight in the sun to relax it and remove
kinks. Follow the procedure in
Cord Tangling
to
avoid and correct tangled cord.
Summary of Contents for 8050 Sport
Page 18: ...Page 18 English NOTES ...
Page 19: ...Page 19 English NOTES ...
