Instr 9928598
Rev 03 2018-04
Page 2 of 4
ASSEMBLY TIME
Approximately 5 minutes
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn
ignition switch to “OFF” position and remove key.
2. Before cover installation:
• Examine vehicle for any accessories that extend
outside of ROPS or vehicle body to ensure
proper fit of cover and prevent damage. Remove
or stow accessories and/or install padding as
necessary.
• Ensure exterior of vehicle is clean. Transporting
a dirty vehicle with cover installed may damage
vehicle finish.
• If not already done, temporarily stow ratchet
A
at left rear corner of cover by folding over and
securing flaps with hook and loop strips.
3. Carefully drape cover
q
over vehicle, pulling
cover as far down over tires as possible.
IMPORTANT
Cover MUST be pulled down below lower surface of
tires, and straps located BELOW lower tire lugs, to
ensure cover stays in place during transport.
NOTE
Exterior of cover has “FRONT” label; ratchet is
located at left rear corner.
RANGER
®
cover shown;
RANGER
CREW
®
similar.
4. Secure front of cover by connecting buckles
B
.
NOTE
LH strap is sewn to edge of cover opening; RH strap
is free to slide in cover pocket. Cover opening
accommodates accessory winch or plow installation
(sold separately).
