Instr 9927735
Rev 01 2016-05
Page 2 of 2
IMPORTANT
Your Tire Mount Kit is exclusively designed for your vehicle. Please read the installation instructions thoroughly
before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to ensure a
satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 5–10 minutes
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn key to
“OFF” position and remove from vehicle.
2. Install two bumpers
e
to mount frame
q
as
shown.
3. Install two LOCK & RIDE
®
expansion anchors
r
to mount frame
q
per anchor kit instructions
EXCEPT as follows: Insert washer
t
between
lever and frame as shown.
4. Ensure all expansion anchors
r
are unlocked,
then install mount frame
q
into bed until anchors
are fully seated as shown. Depress levers to lock
in place.
If installation is loose, remove frame from bed,
tighten nut at base of affected anchor(s), and
reinstall.
NOTE
Install on LH side of bed for front or rear wheel/tire
mounting; RH side installation only permits front
wheel/tire mounting.
5. Install spare tire/wheel (sold separately) to mount
frame
q
using handle
w
as shown. Three
mounting hole options are provided: use hole
which allows tire to rest on vehicle bed.
NOTE
Cone
A
can be reversed as shown to accommodate
different wheel configurations and/or orientation.
TIP
Handle also functions as lug wrench (two sizes).
