32
OPERATION
Failure to operate the ATV properly can result in a collision, loss of control,
accident or rollover, which may result in serious injury or death. Read and
understand all safety warnings outlined in the safety section of this owner’s
manual.
Break-In Period
The break-in period for your new POLARIS ATV is the first ten hours
of operation, or the time it takes to use the first two full tanks of gaso-
line. No single action on your part is as important as following the pro-
cedures for a proper break-in. Careful treatment of a new engine and
drive components will result in more efficient performance and longer
life for these components.
NOTICE:
Excessive heat build-up during the first three hours of operation will
damage close-fitted engine parts and drive components. Do not
operate at full throttle or high speeds during the first three hours of
use.
Engine and Drivetrain Break-in
1. Fill the fuel tank with gasoline. See page 30. Always exercise
extreme caution whenever handling gasoline.
2. Check the oil level. See page 57. Add oil as needed to maintain the
level in the proper range.
3. Drive slowly at first. Select an open area that allows room to famil-
iarize yourself with vehicle operation and handling.
4. Vary the throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 35.
6. Pull only light loads (if equipped with a hitch).
7. Change both the oil and the filter at 20 hours, 200 miles or one
month, whichever comes first.
WARNING
