51
THE PERFECT FIT
FAST M-10 ACE Suspension Adjustments
M-10 ACE Settings
IMPORTANT NOTES:
The time to move one position can take up to 12 seconds depending on
the rear shock loads.
Due to alternator limitations, the ACE module will operate only at
engine speeds above 3500 RPM.
Similar to the FRA on the standard M-10, the ACE module will have
the
MOST
effect on rear suspension performance.
Other M-10 ACE Ride and Performance Settings
Rear Spring Preload
Further fine tuning can be accomplished by adjusting the
preload/crossover collar on the rear spring. This single adjustment
changes
BOTH
the spring preload and crossover transition point.
Increasing this setting will fine tune the overall ride stiffness
AND
increase bottoming resistance so a small change to this setting has a
large effect on ride quality. To adjust the rear spring:
1. Slide the fabric cover toward the top of the rear spring to reveal the
middle spring collars.
2. Using the tool kit spanner wrenches, turn the preload collars to
achieve the desired setting as illustrated.
3. Ensure the fabric cover is replaced correctly and is not interfering
with shock and spring movement.
NOTE:
Refer to the initial set-up chart (on page 52 and under the
hood) for preliminary settings.
Ski Pressure
See the Ski Pressure section for the standard M-10 suspension on page
47.
Track Tension
See the Track Tension section for the standard M-10 suspension on
page 48.
Summary of Contents for 2005 Edge Touring
Page 1: ......
Page 2: ......
Page 4: ......
Page 92: ...89 MAINTENANCE Lubrication L L L L L L L L L L L L L L L L...
