2
Telephone Helpline
: 1300225960
Changing the Setpoint
1) Push the SET key for more than 2 seconds to change the Setpoint value
2) The value of the set point will be displayed and the COMPRESSOR LED starts blinking
3) To change the Set value push the UP and DOWN buttons within 10 seconds
4) To store the new Setpoint push the SET key or wait 10 seconds
Manual Defrost
The appliance will automatically run a defrost cycle every six hours.
To manually defrost the appliance:
1.
Press and hold the DEFROST button for more then 2 seconds.
2.
The defrost cycle will start immediately and the Defrost LED illuminates. .
3.
The next automatic defrost will start six hours after the manual defrost has finished.
Cleaning, Care & Maintenance
•
Defrost appliance at least every 3 months, more often if required.
•
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with water only.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the appliance. Sharp edges can cut.
•
A POLAR agent or qualified technician must carry out repairs, if required.
Stainless Steel Care.
To maintain the stainless steel exterior of your Polar item, please consider the following information:
Never:
•
Use abrasive Scourers or scrubbing pads etc
•
Use Chlorinated or acidic detergents
•
Allow anything e.g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary, clean them off right away.
•
Allow the surface to remain wet.
Do:
•
Clean often.
•
Use soft Cloths or plastic Scourers.
•
Rub with the grain of the metal, rather than across it.
•
Use detergents and polish designed for cleaning Stainless Steel.
•
Ensure that the cleaning products are washed off fully and that the steel is left dry.
Note: The cycle starts from the time the appliance is initially powered up.
Note: Starting a manual defrost also resets the automatic defrost timer.
