5
EN
Telephone Helpline: 1300225960
Pack Contents
The following is included:
• Ice Maker
• Ice scoop
• Inlet/Outlet hoses
• Sealing washers
• Instruction manual
• Backflow prevention valve
• 3/4 connector
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Note: Only use the hoses
supplied with the appliance.
Other hoses are not suitable and
should not be used.
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. Remove the Scoop, Inlet/Outlet hoses and
Sealing Washers from the ice bin.
3. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
4. If necessary, adjust the screw legs of the ice
maker to make it level. The efficiency of the
ice maker can be reduced if the appliance is
unevenly located.
For all plumbing installation, it
must comply with requirements
of AS/NZS 3500.1 and
AS/NZS3500.2, and all other
Local Authority Regulations.
Installing the Drainage pipe
For GK031-A only:
• Please note: this model
drains via gravity - no drain
pump supplied. An optional
drain pump is required if
installing this unit lower
than the drain standpipe.
• Ensure the end of the
drainage pipe is situated
lower than the Water Outlet
valve for efficient drainage.
Gravity drain (For GK031-A only)
5. Connect one end of the corrugated outlet hose
to the water outlet on the rear of the ice maker.
Note:
With the special design of the joints at
both ends, the drainage pipe, after connected,
is featured with strong pulling-resistance and
thus guarantees good watertightness.
6. Attach the other end of the hose to a plumbed-
in stand waste pipe or container suitable for
collecting waste water.
GK031-A_GK032-A_A5_v3_20220216.indb 5
GK031-A_GK032-A_A5_v3_20220216.indb 5
2022/2/16 14:25
2022/2/16 14:25
