4
AU
Telephone Helpline: 1300225960
Pack Contents
The following is included:
• Polar Wine Chiller
• Keys
• Instruction manual
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
WARNING: When positioning the appliance, ensure the supply cord is not
trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance.
Before using your wine chiller
1. Remove all the exterior and interior packaging.
2. Before connecting the chiller to the power supply, let the chiller stand upright for approximately 12
hours.
3. Clean the interior with lukewarm water, using a soft cloth.
4. The door can be opened from either the left or right side. When delivered, the door can be opened
from the left. Should you want to open it from the right, follow the instructions for “reversing the
door swing of your appliance”.
Installing your wine chiller
1. The product is designed to be built-in, recessed, or free standing.
2. Place the chiller on a floor that is able to support it once fully loaded. To level the chiller, adjust the
front levelling leg at the bottom of the chiller.
3. Do not place the chiller in direct sunlight or near other heat sources.
4. Avoid placing the chiller in damp areas.
5. Plug the chiller into the socket.
6. Ensure that the air vent at the front of the chiller is never blocked or covered.
Installing the handle
1. Remove the door gasket on the side you want to install the handle – there are two designated holes
for the handle installation.
2. Install the handle tightly with two screws, lock washers and flat washers provided.
3. Replace the door gasket.
Operating you wine chiller
NB: the chiller should be placed in an area where the ambient temperature is
between 16-35°C.
• When using the chiller for the first time, or re-starting it after a long period of time, there may be
a few degrees variance between the selected temperature and what is shown on the LED readout.
Once the chiller has been switched on for a few hours, this should rectify itself.
• If the unit is unplugged, has lost power or been turned off, wait 3 to 5 minutes before restarting the
chiller.
CM359-A_A5_v1_20191106.indb 4
2019/11/6 16:20
