13
Wireless Devices Country Approvals
Regulatory markings, subject to certification, are applied to the device signifying the radio(s) are approved for use in the following
countries: United States, Canada, and Europe1. Please refer to the Pokini Declaration of Conformity (DoC) for details of other
country markings. This is available at http://www.pokini.de.
1
Europe includes: Austria, Belgium, Bulgaria, Croatia, Czech Republic, Cyprus, Denmark, Estonia, Finland, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovak Republic, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
The device supports WLAN 5150-5350 MHz with indoor usage restrictions.
FCC Compliance Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to
operate the equipment.
FCC type approval ID:
2ABVH-INARI61
RF Exposure Information (SAR)
This model device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured
not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission
of the U. S. Government. The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.
Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest
certified level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device
is designed to operate at multiple power levels so as to use only the poser required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power output.
While there may be differences between the SAR levels of various devices and at various positions, the all meet the government
requirement.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance
with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the
Display Grant section of http://www.fcc.gov/oet/fccid after searching on the below:
FCC ID: 2ABVH-INARI61
This device is compliant with SAR for general population / uncontrolled exposure limits in SNAI / IEEE C95.1-1999 and had been
tested in accordance with the measurement methods and procedures specified in the Office of Engineering and Technology (OET)
Laboratory Division Knowledge Database (KDB), 47 C.F.R. §§ 2.1091 and 2.1093.
Specific Absorption Rate (SAR): 1.17 W/kg
This product has been tested and found to comply with the following standards:
• For the worst case positions, the Pokini TAB A6 is in compliance with the IC RSS 102 Issue 5 (RSS 102) and Federal
Communications Commission (FCC) Guidelines (KDB) 47 C.F.R. §§ 2.1091 and 2.1093 for uncontrolled exposure.
SAR assessment in body worn was conducted with a distance of 15 mm between the housing of the handheld and the flat phantom.
• EM 62311:2008: Assessment of electronic and electrical equipment related to human exposure restrictions for electromagnetic fields (0 Hz – 300 GHz).
Summary of Contents for Tab A6
Page 1: ...Tab A6 Quick Start Guide...
